Set Equalization - Lynx D VA 3120 L Reference Manual

Reference Manual D VA 3120 L Version1.2

Set Equalization

Use this procedure to set the cable equalization for
the module
1. Set Switch 1 to desired mode of operation ON for
1:6 mode or OFF for dual 1:3 mode
2. Set Switch 2
3. Set Switch 3
4. Set switch 4
to be adjusted ON for IN 2 and OFF for IN 1*
(respective LED will flash yellow once indicating
selected channel)
5. Push either the UP or DN push buttons to make the
necessary equalization adjustment for the selected
channel.
6. If using dual mode, set switch 4 to select the
second channel and repeat 5 above.
7. If 10 seconds pass with no further adjustments being
made both channel status LEDS will flash yellow four
times. This confirms settings have been written into
flash ram and stored.
*
This switch is only used / functional when the module is
configured for dual 1:3 mode of operation. If 1: 6 mode of
operation is selected with switch 1, then the IN1 connection is
used by default.
Note. Diagram only
shown for switch
location reference
not actual settings
Page 20
[Gain / Equalization select]
to OFF
[Set Unity]
[select input channel]
to OFF
to select the channel
BUTTONS DIP SWITCH
UP DN 1 2 3
OFF
ON
4