Set Dual 1:3 Or 1:6 Mode - Lynx D VA 3120 L Reference Manual

Reference Manual D VA 3120 L Version1.2

Set Dual 1:3 or 1:6 mode

The D VA 3120 module can be set to one of two
preset modes of operation.
Dual 1:3 Mode. This is a simple 2 x 1 to 3 video
amplifier. Independent left and right channels
passed through the amplifier providing four outputs
for each input channel.
Single 1:6 Mode. This is a simple 1 x 1 to 6 Video
amplifier. The signal on the IN 1 input channel is
passed through the amplifier providing eight
outputs.
Use this procedure to select Stereo or Mono modes
of operation.
1. Set Switch 1 to ON for 1:6 mode* or OFF for dual
1:3 mode
2. If 10 seconds pass with no further adjustment
both channel status LEDS will flash yellow four
times. This confirms setting has been written into
flash ram and stored.
*
When in 1: 6 mode the IN 2 channel indicator will go out.
Note. Diagram only
shown for switch
location reference
not actual settings
Page 18
BUTTONS DIP SWITCH
UP DN 1 2 3
OFF
ON
4