Conversion to another type of gas
To check the first intake of air
a Retaining screw
b Air intake sleeve
Gap X must measure:
For natural gas:
For liquid gas:
50
6 mm
13 mm
If it doesn't:
^ Loosen the retaining screw, adjust
the air intake sleeve, and tighten the
retaining screw again.
^ Finally secure the jets against
inadvertent loosening with sealing
wax.
^ Re-assemble the hob in the reverse
order.
The flame must not go out on the lowest
setting, or when the control is turned
quickly from a high to a low setting.
On the highest setting the flame must
have a distinctive and visible core.