Conversion to another type of gas
Changing the jets
Disconnect the gas hob from the
electricity supply by switching off at
the socket and withdrawing the plug
or by disconnecting the mains fuse.
Turn off the gas supply.
To change the jets, the burner securing
screws must first be loosened and the
upper section of the appliance
removed.
To change the main jet
^ Remove burner caps op, burner
ring q and burner head r.
^ Pull the control knob off.
^ Loosen screws w.
48
^ Remove the upper section of the
appliance carefully. When doing this,
make sure you do not also pull out
the light unit for the display a
located underneath the upper
section. To release the unit, squeeze
together the two clamps b.
^ Whilst counterholding it in place with
an SW 13 spanner, unscrew the main
jet anti-clockwise from its housing
using an SW 10 spanner (see
illustration).
^ Screw in the new main jet, once
again using the spanner to
counterhold the jet housing.