Stainless Steel Surfaces; Pan Support, Control Knob - Miele CS 1021 Operating And Installation Instructions

Stainless steel surfaces

Clean stainless steel surfaces using an
E-Cloth or with a solution of warm water
and a little washing-up liquid applied
with a soft sponge. In the case of
stubborn dried-on soiling, soak first.
Finally, dry with a soft cloth.
If necessary a cleaning agent for
ceramic and stainless steel surfaces
can be used (see "Optional
accessories"). Apply with even
pressure following the direction of the
"grain".
A conditioning agent for stainless steel
can be used after cleaning to help keep
your appliance looking good (see
"Optional accessories").
Apply sparingly with a soft cloth
following the instructions on the
packaging.
Printed surfaces (Flame symbols)
Remove any soiling which comes
into contact with the printed flame
symbols straight away. Soiling,
particularly salty food or liquid and
olive oil, can cause damage if left on
the printed surfaces for a long time.
Do not use stainless steel cleaning
agents on the printed flame
symbols. This would rub off the print.
Cleaning and care

Pan support, control knob

Remove the pan support. Clean the
pan support and the control knob with a
solution of warm water and a little
washing-up liquid applied with a soft
sponge. Stubborn soiling should be
soaked first.
After cleaning dry all surfaces with a
clean cloth.
Do not clean the pan supports in a
dishwasher.
25