Laguna Tools MCNC Creator I-23 Owner's Manual page 52

Symptom
Z-axis depth not consistent each
time same f ile is processed and
af ter machine homes.
Processed workpiece does not
match f ile size.
Machine not stopping at HOME
position
Machine moves reverse
direction when homing
52
MCNC Creator I-23/24
Possible Cause
Working speed exceeds Z-Axis
maximum speed.
Loose coupling or transmission
slipping.
Incorrect plunge speed in design
sof tware.
Pulse equivalent incorrect.
Incorrect post processor.
Wrong cutting tool used.
HOME detection plate beyond
reach of proximity sensors.
Proximity sensor wire is loose or
damaged.
Proximity sensor damaged.
Poor connection at Interf ace
board.
50-pin data cable is broken.
Incorrect HOME direction
settings in Machine Setup
50-pin data cable is broken.
Correction
Set to saf e speed in:
MENU/Machine Setup/Max
Speed Limit.
Tighten connecting parts.
Check speeds, verif y correct
post processor is being used.
Adjust pulse under:
MENU/Machine Setup.
Verif y that correct post
processor was used.
Use proper tool f or process.
Inspect and adjust
Check connections.
Test and Replace.
Inspect the appropriate
connection.
Replace Cable.
Check settings.
Replace data line.