Table of Contents
Advertisement
Symptom
Controller keeps restarting
automatically.
Controller display reads "Out of
Limit"
Cannot set work origin on
controller.
Z-axis f all is too f ast during
processing
MCNC Creator I-23/I-24
Possible Cause
Insuf f icient power supply.
Local power grid unstable.
Controller damaged.
HOME operation has not been
perf ormed.
Design too large to f it within
machine limits.
Incorrect table size.
May be in Machine Coordinate
State
Buttons not f unctioning
Working speed exceeds Z-axis
maximum speed
Loose coupling or transmission
slipping
Incorrect plunge speed in design
sof tware.
Correction
Have qualif ied electrician check
incoming power supply.
Contact power company.
Connect controller to computer
via USB cable. If problem still
occurs, replace controller.
HOME all axes and retry.
Check ORIGIN placement and
design size.
Check table size parameters in
Machine Setup.
Press MENU + 1 to revert to f irst
working coordinate system.
Enter MENU/System
Setup/Buttons Check to verif y
f unction. If buttons not working,
replace controller.
Set to saf e speed in:
MENU/Machine Setup/Max
Speed Limit
Tighten connecting parts.
Check speeds, verif y correct
post processor is being used.
51
Advertisement
Table of Contents
