Laguna Tools MCNC Creator I-23 Owner's Manual page 35

The parameters in Machine Setup are set by the
manufacturer. It is normally not necessary to change the
default settings. Please consult a Laguna Tools technician
before making any changes.
Pulse Equiv (Pulse Equivalence) - Set the number of pulses sent to the motor f or every 1 mm of
movement.
Table Size – Establish the machine table size as the sof t limit values to prevent overtravel.
Spindle Setup – Set the Spindle Delay and Spindle State.
Spindle Delay – Set the time delay in microseconds between reading the f ile and starting or stopping the
spindle.
Spindle State – Set the signal control parameters of the spindle.
Home Setup – Set Home Speed and Home Order.
Home Speed – Set the spindle speed f or each axis. Def ault X/Y speed: 3000 mm/min, def ault Z
speed: 1800 mm/min.
Home Order – Set the sequence in which the spindle homes.
Home Direction – Set the positive or negative direction f or each axis.
Toolset Setup – Set C.A.D. Position, C.A.D. Thickness, and Toolset Speed.
C.A.D. Position – Set the placement of the Z-Axis.
C.A.D. Thickness – Set the thickness of the Touch-Of f puck. Def ault is 25.000 mm.
Toolset Speed – Set the speed of the Z-Axis during toolset operations.
Accel (Acceleration) – Set the acceleration speed. Def ault acceleration is 800 mm/s
Start Spd (Start Speed) – Set speed of skip and completion.
Voltage Setup – Set input and output terminal status.
Max Spd Limit (Maximum Speed Limit) – Set the maximum speed of the router head. Def ault X/Y
speed: 60,000,000, def ault Z+: 1800, def ault Z-: 3000.
MCNC Creator I-23/I-24
NOTE
2
.
35