Table of Contents
Advertisement
S A F E T Y I N S T R U C T I O N S A N D G U I D E L I N E S
• DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow
approximately 15 minutes for the fixture to cool down before serving.
• DO NOT shake fixture, avoid brute force when installing and/or operating fixture.
• DO NOT operate fixture if the power cord has become frayed, crimped and/or damaged.
If the power cord is damaged, replace it immediately with a new one of similar power rating.
• DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never
blocked. Allow approx. 6" (15cm) between fixture and other devices or a wall for proper
cooling.
• When installing fixture in a suspended environment, always use mounting hardware that
is no less than M10 x 25 mm, and always install fixture with an appropriately rated safety
cable.
• Always disconnect fixture from main power source before performing any type of service
and/or cleaning procedure. Only handle the power cord by the plug end, never pull out
the plug by tugging the wire portion of the cord.
• During the initial operation of this fixture, a light smoke or smell may emit from the interior
of the fixture. This is a normal process and is caused by excess paint in the interior of
the casing burning off from the heat associated with the lamp and will decrease gradually
over time.
• Consistent operational breaks will ensure the fixture will function properly for many years
to come.
• Use the original packaging and materials to transport the fixture in for service.
L E D L I F E
The average LED Life (hours) may vary depending on several factors including but not
limited to: Environmental Conditions, Power/Voltage, Usage Patterns (On-Off Cycling),
Control and Dimming.
8
Advertisement
Table of Contents
