Led Status Lights - Planar Dome C2 Reference Manual

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Configure Display Settings
Configure Windowing
DPMS Screen Saver
Console Modification
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
Video Modes
Connector Ports

LED Status Lights

USB Connection
LED Status Lights
The two LEDs on the back panel provide information about the display.
• LED A describes the digital-link status between the DX2 display controller and the interface.
• LED B describes the display-panel status. it shows any faults currently in the panel.
Power-up sequence information from LED
LED A Action/Sequence
Solid green Initial power-on
Solid red One (1) second after power-on
Solid yellow Two seconds after power-on
Flashing red Link working, unrecognized sync
information
Flashing yellow n seconds after power-on
Dome CX Display System for Solaris
Reset button (left) and LEDs on interface plate
LED A, top
LED B
LED B Description
Solid green One (1) second of solid green to verify
the green LED works.
Solid red One (1) second of solid red to verify the
red LED works.
Solid yellow One (1) second of solid yellow to verify
the yellow LED works.
Flashing red Internal fatal fault was discovered during
power-on self-test.
Flashing yellow Service fault was discovered during
power-on self-test.
34