Troubleshooting; Specifications - Planar Dome C2 Reference Manual

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Configure Display Settings
Configure Windowing
DPMS Screen Saver
Console Modification
Dome CXtra Software
APPENDIXES

Troubleshooting

Specifications

Video Modes
Connector Ports
LED Status Lights
USB Connection
Troubleshooting
Problem Possible cause
No image appears on Computer is not powered on.
the screen
Power cord is not securely connected.
Video cable connected incorrectly.
No display on console; Switch 1 on DIP switch S2 is set for VGA mode.
system does not boot
Incorrect resolution settings Switch 2 on DIP switch S2 is set incorrectly
for EPROM.
Dome CX Display System for Solaris
Solution
Turn on computer.
Tighten power cord connection and turn on computer.
Make sure the first display of a dual-headed system or the
only display of a single-headed system is connected to the
Video 1 port on the DX display controller. (See
Disable VGA on all DX boards you install. Slide switch 1 on
DIP switch S2 into the OFF position.
Check that EPROM is enabled if you want to set resolutions
via the driver. Slide switch 2 on DIP switch S2 into the
ON position.
If you want to override default resolutions, use DIP switch S1.
See page 13.
page 9.)
25