Planar Dome C2 Reference Manual page 24

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Configure Display Settings
Configure Windowing
DPMS Screen Saver
Console Modification
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
Video Modes
Connector Ports
LED Status Lights
USB Connection
To modify the OWconfig file
NOTE: The resolution for the Dome C3 — 1536x2048 — is used throughout this
example. Substitute 1200x1600 for the Dome C2 and 2048x2560 for the Dome C5i.
This section explains the first example from the preceding sample code, line by line,
and tells how to modify those lines to match the device you are installing.
class="XSCREENCONFIG" name="DOMEdxpci0Config"
The provided here must be unique in the
name
long as you select a that is not used for any other
name
device="/dev/dxpci0.0"
This line indicates the installation of a DX board to which the system assigned the
instance of zero (0). The second zero (0) indicates that you are using the first head. To
modify this line for the device you are installing, replace the first zero (0) with the
instance the system assigned to your board. For the second head, replace the
second zero (0) with a one (1).
res="1536x2048 Panel"
This line indicates that the resolution of your flat panel (pre-adjusted timing name) is
"1536x2048 Panel".
monitor="domegray.vda"
This line indicates that you are using a grayscale display and that the pre-adjusted
timing name is located in the display file
Display files are located in the
/opt/DOMEdxpci/monitors
Do not modify these files unless DOME Support advises you to do so.
board="dxpci-2hd.xqa"
This line indicates that you are using two heads (
that the configuration of the board is located in the board file
The board file is located in the
/opt/DOMEdxpci/boards
these files.
See the second code sample on
Dome CX Display System for Solaris
file. You can alter it as
OWconfig
XSCREENCONFIG
.
domegray.vda
directory.
) of a DX board (
-2hd
dxpci-2hd.xqa
directory. Do not modify
page 13 for configuration of the second head.
Modifying code for resolution
When you modify the line
res="1536x2048 Panel",
use the exact name for your display
from the "Pre-Adjusted Timing
Name" column in the table on
page 32.
section.
NOTE: The resolution for the
Dome C3 — 1536x2048 — is used
throughout this example. Substitute
1200x1600 for the Dome C2 and
2048x2560 for the Dome C5i.
Supporting color displays
To support a color display, use
"domecolr.vda" in place of
"domegray.vda"
), and
dxpci
.
.
14