Figure 2-18. Transmission Hump Trunnion Mounting - Motorola APX 7500 05 Installation Manual

2-16
2.2.1 Dash Mount with Trunnion
NOTE: This configuration is not applicable for 100W radios.
1. Select the location to mount your radio on the transmission hump (see
the dash (see
NOTE: When mounting the trunnion on the transmission hump take care the transmission housing is
not affected. Plan your installation ensuring enough room for the Accessory connector and
cable in the back of the radio.
2. Using the trunnion mounting bracket as a template, mark the positions of the holes on the
mounting surface. Use the innermost four holes for a curved mounting surface such as the
transmission hump, and the four outmost holes for a flat surface such as under the dash.
3. Center punch the spots you have marked and realign the trunnion in position.
4. Secure the trunnion mounting bracket with the four self-drilling screws provided
(see Figure 2-18
5. Ensure that the plastic guides are aligned (horizontal) to the grooves of the trunnion. Slide the
radio into the grooves until it snaps into place (see
Figure 2-19).
and Figure 2-19).
Screw
Trunnion
Threaded Hole
for Screw

Figure 2-18. Transmission Hump Trunnion Mounting

Standard Configurations: Radio Mounting
Figure 2-19).
Sheet-Metal Screws
(0312002B14)
Tabs
Plastic
Guides
Screw
Groove
Figure 2-18) or under
6878215A01