Standard Configurations: Microphone Hang-Up Clip
2.6
Microphone Hang-Up Clip
2.6.1
Standard or O3 Control Head Hang-Up Clip
The hang-up clip must be within reach of the operator(s) and close enough to the control head to
prevent cable strain. Measure this distance before actually mounting the bracket. Since the bracket
has a positive-detent action, the microphone can be mounted in any position.
Use the hang-up clip as a template to locate the mounting holes. To avoid interference when
removing the microphone, install the flathead screw in the top clip hole.
Some microphone models require the grounding of the microphone clip in order for HUB operation to
work correctly. Refer to the documentation that comes with your Motorola microphone model.
NOTE: For multi-control head configuration where only one of the control heads has a microphone,
the control heads without a microphone attached must have their HUB or Monitor pin
(J100-22) jumpered by a wire to GND (J100-1 or J100-14) for HUB operation to work.
2.7
RFID (Option)
An APX 7500 mobile radio equipped with an RFID tag allows an alternate option for tracking the
radio asset. Each RFID equipped radio has an RFID tag preprogrammed with the individual radio's
serial number (also found on the FCC label) as well as band and radio model information (see below
for further info).
6878215A01
Figure 2-50. RFID Location on Mid Power Radio
Figure 2-51. RFID Location on High Power Radio
RFID Tag
RFID Tag
2-39