Motorcycle Radio Installation: Installing Antenna Base and Cables
12. Attach the 7/800, VHF or UHF antenna base per Antenna Installation Manual.
IMPORTANT:
13. Route the coaxial cable for the 7/800, VHF or UHF antenna(s) through the cable clamps per
Figure 5-11
!
Be sure to observe the correct routing of the antenna cable. Failure to do so can damage the
cable.
C a u t i o n
14. After routing cable, allow enough of the cable to reach the radio's antenna connector and cut
off any excess length of the cable.
15. Install the connector per Antenna Installation Manual.
6878215A01
Antenna Placement and Cable Routing in the Antenna Installation
Manual is not applicable for the APX series.
for Band 1 and
Figure 5-12
Cable
Clamp
Coaxial
Cable
Attach to Antenna
Connector on
Radio Band 1
Figure 5-11. Routing the Coaxial Cable for Band 1
Cable
Clamp
Coaxial
Cable
Figure 5-12. Routing the Coaxial Cable for Band 2
for Band 2.
Attach to Antenna
Connector on
Radio Band 2
5-17