1-2
1.2
Standard Configurations
1.2.1
Dash Mount Configuration
NOTE: The dash mount configuration is not applicable for 110W radios.
In the dash mounting version of the XTL 2500, the control head is mounted on the front of the
transceiver housing. Electrical connection between the two takes place within the radio via a flexible
circuit board between the connectors on the front of the transceiver and at the back of the control
head.
For details on this configuration, see
1.2.2
Remote Mount Configuration
In the remote control version, the transceiver and the control head are mounted separately in the
vehicle. The control head is mounted in a remote trunnion near the operator. The transceiver is
mounted by means of a trunnion or other mounting hardware. If the transceiver is located in a car
trunk, be sure that secure mounting and sufficient cooling are provided. Do not cover the transceiver
with baggage, blankets, etc.
NOTE: The keypad mic should only be plugged in the GCAI 1.
October 12, 2005
Figure 1-3. Dash Mount Configuration
Section 2.2.1 on page
GCAI 1
Figure 1-4. Remote Mount Configuration
Introduction: Standard Configurations
2-7.
GCAI 2. Not for Keypad Mic
MAEPF 28253 O
HLN6923A