Motorcycle Configurations; Base/Control Stations; Tools Required For Apx 7500 Installations - Motorola APX 7500 05 Installation Manual

1-8
1.3

Motorcycle Configurations

NOTE: The motorcycle configurations are not applicable for 100W radios and O9 control heads.
The ASTRO APX 7500 motorcycle radio models provide most of the equipment needed for installing
a standard ASTRO APX 7500 radio on a motorcycle. Most of this radio system is standard
equipment. See Chapter 5: Motorcycle Radio Installation for further information.
1.4

Base/Control Stations

NOTE: The base/control station option is not applicable for 100W radios and O9 control heads.
If mobile radio equipment is installed at a fixed location and operated as a control station or as a
fixed unit, the antenna installation must comply with the following requirements in order to ensure
optimal performance and compliance with the RF energy exposure limits in the standards and
guidelines listed in the 6881095C99 manual:
• The antenna should be mounted outside the building on the roof or a tower if at all possible.
• As with all fixed site antenna installations, it is the responsibility of the licensee to manage the
site in accordance with applicable regulatory requirements and may require additional
compliance actions such as site survey measurements, signage, and site access restrictions in
order to ensure that exposure limits are not exceeded.
1.5

Tools Required for APX 7500 Installations

Tool
10 mm wrench
5 mm Allen wrench
Rubber-coated pliers
Regular slot screwdriver of Phillips #2
Pin removal tool
RF antenna tool
Introduction: Motorcycle Configurations
Part Number
–
–
–
–
6680163F01
HLN6695_
6878215A01