Honeywell MILLER TURBOLITE+ Series User Manual page 15

TABLE 3: ANSI Z359.14 and CSA Z259.2.2: Inspection Requirements
Application
Type of Use
Examples
Infrequent Rescue & con-
to Light fined space,
Factory
maintenance
Moderate to Transportation,
Heavy Residential
construc-
tion, Utilities,
Warehouse
Severe to Commercial
Continuous construction,
Oil & Gas,
Mining
1) Failure of a worker to perform "before each use" inspection or failure of an inspection by a worker shall initiate the requirement for inspection by a
competent person.
2) Failure of a competent person to perform inspections as specified in this Table, or failure of an inspection by the competent person shall initiate product
revalidation or disposal.
3) Determination of the type of use category shall be determined by a competent person.
4) A SRL that is considered non-repairable, or not designed for disassembly such that internal inspection is not possible without rendering it unserviceable, is
not subject to revalidation inspection. These SRL's shall have service life and other inspection requirements as provided by the manufacturer's instructions.
Conditions of Use
Good storage conditions,
indoor or infrequent outdoor
use, room temperature,
clean environments
Fair storage conditions, in-
door and extended outdoor
use, all temperatures, clean
or dusty environments
Harsh storage conditions,
prolonged or continuous
outdoor use, all tempera-
tures, dirty environment
15
Competent
Worker
Person
Inspection
Inspection
Frequency
Frequency
Before each Annually
use
Before each Semi-annually
use to annually
Before each Quarterly to
use semi-annually
APPLIES TO CSA
ONLY Product
Revalidation
Frequency
At least every
5 years but not
more than inter-
vals required by
the manufacturer
At least every
2 years but not
more than inter-
vals required by
the manufacturer
At least annually
but not more than
intervals required
by the manufac-
turer