Leica Q3 Instruction Manual page 241

Menus and displays
Electronic viewfinder is dark
Display language is not English
Electronic viewfinder is dark
Viewfinder is out of focus
The LCD panel is to dark or too bright/not
clear
menu does not appear
Favorites
Live View stops suddenly or doesn't start
The brightness in Live View mode is not the
same as in the images
The number of remaining shots does not count
down after shooting
Shooting
Image noise appears on the LCD panel/in the
viewfinder when the shutter button is pressed
to the first pressure point
LCD panel/viewfinder deactivates after a very
short time
The display switches off after shooting/the
LCD panel goes dark after shooting
Flash won't fire
The flash does not fully illuminate the object
EVF brightness is set too low
-
Switchover between EVF and LCD incorrectly set
The brightness setting is incorrect
Viewing angle is too small
Brightness sensor is blocked
The favorites menu is empty
The camera is hot due to high ambient temperature,
extended Live View operation, extended video shooting or
continuous shooting
The brightness settings for the LCD panel have no
influence over the exposures
Exposure preview is deactivated
The image requires only very little memory space
The gain is increased to aid image composition if the
object is insufficiently lit with reduced lens aperture
Power Save settings are activated
Flash loads after shooting, LCD panel deactivates during
load time
The flash cannot be used with the current settings
Battery is depleted
Pressing the shutter button while flash is still loading
Electronic shutter function is selected
Automatic bracketing or continuous shooting is activated
Object is outside the flash range
Flash is covered
Set the EVF brightness
Select in the menu
English Language
Select a suitable setting
Check the diopter setting and adjust as needed
Adjust the display brightness
View the LCD panel at a perpendicular angle
Make sure that the brightness sensor is not blocked
Add at least one function
Allow camera to cool down
Adjust the brightness settings as needed
Activate the function
This is not a fault; the number of remaining shots is
calculated as approximations
Not a fault – image quality will not be impacted
Change the settings as needed
Wait until the flash is charged
Refer to the list of flash function-compatible settings
Charge or replace the battery
Wait until the flash is loaded
Change the setting
Change the setting
Move object into flash range
Make sure the flash unit is not covered by your finger or
some object
241
FAQ