Table of Contents
Advertisement
Problem solving guide
A fault message appears in the display
Message
p
Water intake fault
Open the stopcock
and
check the inlet hose.
,
Technical fault
,
Fault
Disinfection
temperature
not reached
q
Drain fault
Clean the drainage
system.
Fill the container
or
O
Fault
Container empty
A To switch off the fault message, press the multi function selector.
42
Possible cause
The water inlet is
blocked or restricted.
The water pressure is
too low.
There is a fault.
During the disinfection
programme the water
temperature was not
reached.
The water outlet is
blocked or restricted.
One of the external
detergent containers is
empty.
Remedy A
Check whether
– the stopcock is opened
enough.
– the inlet hose is kinked.
– Select Low water
pressure in the
Settings/Supervisor level
menu.
Start the programme again.
If the fault message appears
again, contact the Service
Department.
The machine has not
carried out the disinfection
cycle correctly.
Start the programme again.
LP version: Clean the
drainage system.
AV version: Call Service.
See "Detergent - Empty
sensor".
Advertisement
Table of Contents
