Table of Contents
Advertisement
Connection to the hot water supply
To keep electricity consumption costs
down this machine can be connected
to a (ring) piped hot water supply, max.
temperature 70°C. It is not economical
to run it from an individual hot water
supply if it is not in continuous use, as
the water in the supply pipes cools
down and more energy would be
required to reheat the water. For hot
water connection the same conditions
apply as for cold water connection.
The inlet hose with the red stripes (hot
water hose) is connected to the
stopcock.
For operational reasons the machine
must not be connected to hot water
only.
If the machine is not connected to a hot
water supply, the hot water inlet hose
must be disconnected and the water
settings for the main wash, pre-wash
and rinses must be reprogrammed.
^ Select the cold option in the Settings
menu/Supervisor level/menu.
The programme durations may be
longer.
^ Disconnect the hot water hose (hot
water - red stripes)
^ Plug the inlet hole with the blanking
cap supplied.
Recycled water connection
This machine can be connected to a
recycled water supply.
^ Unscrew the blanking cap from the
recycled water valve.
^ Connect the additional inlet hose to
this valve.
The main wash and rinses water
settings must then be set as
appropriate.
^ Go to Settings menu/Supervisor level
menu and select the Recycled water
option.
Connection to a very hot water
supply
It is possible to connect the machine to
a very hot water supply, 70°C to a
maximum of 85°C. A special inlet hose
is required. The machine must also be
reprogrammed by a Miele service
technician or Miele authorised service
dealer.
Installation
59
Advertisement
Table of Contents
