Table of Contents
Advertisement
10. Untie and discard the wire tie on the Main Wire
(25). Route the Main Wire upward through the
Handlebar (4) as shown.
Then, route the Extension Wire (70) upward
through the Handlebar (4) as shown.
Have a second person hold the Console (7)
near the Handlebar (4) until step 11. Plug the
Main Wire (25), the Pulse Wire (23), and the
Extension Wire (70) into the receptacles on the
Console.
The connectors on the Wires (23, 25, 70)
should slide easily into the receptacles and
snap into place. If a connector does not slide
easily into a receptacle, turn the connector and
try again. If you do not connect the con-
nectors properly, the console may become
damaged when you use the exercise bike.
Then, insert the excess wire into the
Handlebar (4).
11. Tip: Avoid pinching the wires. Attach the
Console (7) to the Handlebar (4) with two M4
x 16mm Screws (2) in the lower holes in the
Handlebar.
10
7
11
7
Avoid pinching
the wires
11
70
25
4
23
70
25
4
2
Advertisement
Table of Contents
