Table of Contents
Advertisement
8. Orient the Shield Cover (26) as shown.
While a second person holds the Shield Cover
(26), connect the Receiver Wire (69) on the
Shield Cover to the Extension Wire (70) in the
Upright (27).
Tip: Avoid pinching the wires. Press the
Shield Cover (26) onto the Left and Right
Shields (37, 58).
9. Orient the Console Cover (3) as shown, and
slide it onto the Upright (27).
Tip: Avoid pinching the wires. Insert the
Pivot Bracket (11) on the Handlebar (4) into the
Upright (27).
Attach the Pivot Bracket (11) with two M8 x
58mm Bolts (24) and two M8 Locknuts (17).
Make sure that the Locknuts are in the hex-
agonal holes.
Tip: If necessary, rotate the Handlebar (4) to a
different angle so that there is sufficient space
to tighten the M8 x 58mm Bolts (24) into the
Upright (27).
8
Avoid pinching
the wires
37, 58
9
Avoid pinching
the wires
4
10
26
69
70
11
Hexagonal
17
Holes
24
3
27
27
Advertisement
Table of Contents
