Table of Contents
Advertisement
Steps:
1. Paste the drill template to desired mounting place. Drill the screw
hole and cable hole according to the supplied drill template
(shown as Figure 2-3).
2. Align the screw holes of the junction box to the drill template, and
fix the junction box to the wall with screws.
3. Hang the camera with the safety rope of junction box.
4. Route the cables.
5. Fix the camera to the junction box with screws.
6. Adjust the surveillance angle according to step 3 in Section 2.2.
7. Install the water-proof jacket according to Section 2.5.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Network Bullet Camera·Quick Start Guide
Figure 2-7 Dimension of Junction Box
18
Advertisement
Table of Contents
