Table of Contents
Advertisement
If the remote control cannot operate normally, please take the batteries out, and then reinsert it 30s
later; if it is also abnormal, please replace the batteries.
If the main unit needs to be remote controlled, please aim remote controller at the receiver of main
unit in order to improve the receiving sensitivity of the main unit.
When the remote controller sends out single, a make
ring if the main unit receives effect signal.
"*" There is no this function for these units ：FSL-850B-H-3F 、 FSOL-850B-3F
9 WEEKLY TIMER FUNCTION
9.1 7DP - Seven days programmer (Accessory not supplied)
Centralized Control and Week Timer Functions: The centralized controller and the weekly timer
are integrated in the same wire controller. The system has both the centralized control and the week
timing functions. Up to 16 sets of units can be controlled simultaneously by the centralized controller
(weekly timer). The weekly timer has the function of invalidating the lower unit. The weekly timing
function is able to realized four timing ON/OFF periods for any unit everyday, so as to achieve fully
automatic operation.
This WEEKLY TIMER adopts 485 modes to communicate with manual control of every duct type
unit, and it can control up to 16 units. Adopting2-core twisted-pair wire, the longest communication
distance of this TIMER is 1200m. After connected to power, the WEEKLY TIMER can display all
connected units (sequence of unit is determined by code switch of manual control of every duct type
unit). On and off of every duct type unit can be done through the Timer On / Off of this WEEKLY
TIMER, and the button shield operation of manual control can be done through shield setting on
WEEKLY TIMER. Mode selection and temperature adjustment and other operations are done through
the manual control at every unit.
will flicker for about 1s.The bell will
23
Advertisement
Table of Contents
