Table of Contents
Advertisement
9.2 Install the weekly timer function
◆ A pit or a hole in the suitable position of the wall should be reserved for the connection signal
cables.
◆ The connection wire between indoor unit and controller can be laid in the pit with 1# PVC pipe
for direct installation (Figure 10.5). For concealed installation, 1# PVC can also be utilized (Figure
10.6).
◆ Both Cable of direct installation and the concealed one, please drill two horizontal hole on the
wall and insert two wooden plug. Then fix the soleplate on the wall and insert the signal wire pin into
the plug as showed in Figure10.7, finally fix the controller to the wall..
Fig. 10.5 Cable of
direct installation
Serial
Name
Fig.10.6 Cable of
concealed installation
1
Wall
Soleplate
2
3
Screw M4X10
25
Fig.10.7 Schematic
4
Controller Panel
Advertisement
Table of Contents
