Table of Contents
Advertisement
function and "
•
Please put the remote controller near user when this function
is set. Do not put the remote controller near the object of high
temperature or low temperature in order to avoid detecting
inaccurate ambient temperature.When I SENSE function is turned
on, the remote controller should be put within the area where
indoor unit can receive the signal sent by the remote controller.
Sleep function
Press "Clock" and "Light" buttons simultaneously, can select Sleep 1 (
), Sleep 2(
these, after electrified, Sleep Cancel is defaulted.
•
Sleep 1 is Sleep mode 1, in Cool modes: sleep status after run for
one hour, the main unit setting temperature will increase 1 , two
hours, setting temperature increased 2 , then the unit will run at
this setting temperature; In Heat mode: sleep status after run for
one hour, the setting temperature will decrease 1 , two hours,
setting temperature will decrease 2 , then the unit will run at this
setting temperature.
•
Sleep 2 is sleep mode 2, that is air conditioner will run according to
the presetting a group of sleep temperature curve.
•
Sleep 3 the sleep curve setting under Sleep mode by DIY;
(1) Under Sleep 3 mode, press "Health" button for a long time,
remote controller enters into user individuation sleep setting status,
at this time, the time of remote controller will display "1HOUR",
the setting temperature "88" will display the corresponding
temperature of last setting sleep curve and blink (The first entering
will display according to the initial curve setting value of original
factory);
(2) Adjust " + " and " - " button, could change the corresponding
setting temperature, after adjusted, press "Health" button for
confirmation;
(3) At this time, 1hour will be automatically increased at the timer
position on the remote control, (that are "2HOUR" or "3HOUR" or
"8HOUR"), the place of setting temperature "88" will display the
corresponding temperature of last setting sleep curve and blink;
(4) Repeat the above step (2)~(3) operation, until 8 hours
temperature setting finished, sleep,curve setting finished, at this
time, the remote controller will resume the original timer display;
" will disappear.
), Sleep 3 (
) and cancel the Sleep, circulate between
21
GB
Advertisement
Table of Contents
