Replacement Of Bateries In Remote Controller; Emergency Operation - Toyotomi UTG-17AP User Manual

BASIC OPERATION GUIDE
1 After putting through the power, press "ON/OFF" button or remote controller
to turn on the air conditioner. Press it again to turn it off.
2 Press "MODE" button to select your required mode: AUTO, COOL, DRY,
FAN, HEAT.
3 Press or button to set your required temperature. Temperature cannot
be adjusted under auto mode.
4 Press "FAN" button to set your required fan speed: auto, low speed, low-
medium speed, medium speed, medium-high speed, high speed.
5 Press button to select fan blowing angle.

REPLACEMENT OF BATERIES IN REMOTE CONTROLLER

1 Press the back side of remote controller marked
with and then push out the cover of battery box
along the arrow direction.
2 Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" and "-" polar are
correct.
3 Reinstall the cover of battery box.
NOTICE:
§
During operation, point the remote control signal sender at the receiving
window on indoor unit.
§
The distance between signal sender and receiving window should be no
more than 8 m, and there should be no obstacles between them.
§
Signal may be interfered easily in the room where there is fl uorescent lamp
or wireless telephone; remote controller should be close to indoor unit
during operation.
§
Replace new batteries of the same model when replacement is required.
§
When you do not use remote controller for a long time, please take out the
batteries.
§
If the display on remote controller is fuzzy or there is no display, please
replace batteries.

Emergency operation

If remote controller is lost or damaged, please use auxiliary button to turn
Signal sender
83
battery
reinstall
remove
cover of battery box
GB