Table of Contents
Advertisement
not displayed.
•
When the remote controller is turned off, power limiting function
is cancelled. If you want to activate the function, please repress
"Mode" and "Light" buttons simultaneously.
•
If the current power is lower than the maximum power of
then the power will not be limited after entering into such mode.
•
For the model with one outdoor unit and two indoor units, if
any one of indoor units enters into power limiting function, the
outdoor unit will enter into the set limiting power mode of indoor
unit; when two indoor units enter into power limiting mode, then
the power of outdoor unit will be limited according to the lower
power of the two indoor units.
NOTE
•
This function is not available.
Indoor ambient temperature
By holding " On/Off " and "
indoor ambient temperature on indoor unit's display. The setting on
remote controller is selected circularly as below:
When selecting "
indoor unit displays indoor ambient temperature.
Clean reminder function of filter
The reminder function is defaulted to be OFF. Hold " On/Off " and "
" buttons simultaneously for 5s to turn it on. The buzzer will give out
sound for 0.5s and the dual-8 nixie tube on the display will be on for
3s; Once the reminder function is turned on, when the air conditioner
has reached to the set time, the dual-8 nixie tube will flash about 30s
when the unit is turned on each time to remind the user to clean the
filter; you can turn off this cycle reminder by holding " On/Off " and
"
" buttons simultaneously for 5s and then the air conditioner will
count time again.
NOTE
•
Once the reminder function is turned on, only this cycle reminder
" buttons simultaneously, you can see
blank
No Setting
" with remote controller, temperature indicator on
19
mode,
GB
Advertisement
Table of Contents
