Toyotomi TKN-2328R32 User Manual page 44

1. Remove the wire clip; connect the po wer connection wire and signal control
wire (only for cooling and heating unit) to the wiring terminal according to the
Note: The wiring board is for reference only. Please refer to the actual one.
Installation of outdoor unit
2. Fix the power connection wire and signal control wire with wire clip (only for
cooling and heating unit).
Note:
Step six: neaten the pipes
1. The pipes should be placed along the wall,
bent reasonably and hidden possibly. Min.
semidiameter of bending the pipe is 10cm.
2. If the outdoor unit is higher than the wall
hole, you must set a U-shaped curve in the
pipe before pipe goes into the room, in
order to prevent rain from getting into the
room.
12K Heat pump type:
、
2 3
N(1)
L
N
blue black brown blue brown
yellow-
(black)
green
N L
Indoor unit connection POWER
44
18 、 24K Heat pump type:
N(1) 2
yellow- b u l e black brown
green
yellow-
green
Indoor unit connection
U-shaped curve
3 L N
brown b u l e yellow-
(black)
green
L N
POWER
wall
drain hose
GB