JPT YDFLP-E-80&100-M7-M-R User Manual page 22

After selecting full control mode, user can set power, frequency, pulse width and then
press "edit" button to confirm. User can switch on/off emission when clicking "Laser" button.
Note: All the parameters except power can't be modified during emission.
Control MO signal
3
Ctrl MO: The "MO" button will be appeared on the interface after selecting Ctrl MO. User
can control the switching of MO signal while clicking this button. This setting will not be
preserved after power off.
2)Default parameter setting and selection
① Selecting red beam/laser priority mode
Figure 20 Selection Red Beam/ Laser Priority Mode
Figure 18 Setting parameters and emitting
Figure 19 GUI control MO state
YDFLP-E-80&100-M7-M-R User Manual
18 File Number:
JG-MCYF-SM-0039