SEAL 54 EL-1 Instruction Manual page 27

5.4.6 Decaling
When decaling, a laminate is put over the image and an adhesive is put on the backside of the image.
1. Load and web laminating films in the upper and the lower section as described in section 5.3.3.
2. Feed the images into the nip, allowing a gap between them.
3. Cut the result with a safety blade cutter when the images are clear of the rollers.
This decal can later be mounted onto a panel or other substrate.
5.5 Unloading
To unload the machine:
1. Cut the result after the last image (panel after the leader panel).
2. Cut both films 1" (25 mm) above roller surface using a safety blade cutter.
3. Open up the nip and remove the (leader panel and) films from the rollers at the rear.
To unload a roll from the shaft:
4. Take out the autogrip shaft (See 5.2.1).
5. Remove the material roll from the autogrip shaft
6
CLEANING/MAINTENANCE
The machine has to be cleaned regularly. Dirt and dust will have a negative influence on the result of
the lamination processes.
CAUTION:
Do not use abrasive materials for cleaning the machine. This can damage the painted
surfaces or the silicone covering of the rollers.
Use a damp cloth for cleaning.
CAUTION:
Make sure water does not run into any of the cabinets. This can damage the electrical
circuits when power is applied.
Clean the exterior of the machine with a damp cloth as needed. If necessary, use a household-
cleaning solution to remove difficult marks.
Clean the shafts and the rubber cords as required.
22
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920