SEAL 54 EL-1 Instruction Manual page 30

Pressure too low.
Figure 22: Wrinkles due to low pressure.
•
Contact your dealer and ask for technical assistance.
Unwind tension too low.
Figure 23: Wrinkles due to low unwind tension.
•
Increase the unwind tension until the wrinkles (6) in the film on the roller disappear. The lines (7)
in the process result will disappear as well.
Roller alignment fault.
Figure 24: Wrinkles due to faulty roller alignment.
The wrinkles occur on one side only (left or right).
•
Contact your dealer and ask for technical assistance.
7.2 Technical assistance
For technical assistance you can contact your dealer or see
Make a clear description of the problem before contacting technical assistance.
Please keep the type and serial number of your machine at hand. You can find this data on the
identification plate of your machine, which can be found on the rear side of the right cabinet.
www.sealgraphics.com
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
for information.
25