SEAL 54 EL-1 Instruction Manual page 22

CAUTION:
Never use an open blade near the rollers. Cutting or scoring the rollers will damage
the rollers and cause reduced performance resulting in low quality finished product.
5.3.2 Single Sided Process Webbing
Figure 16: Webbing upper section.
1. Pull the film forward until approximately 10 cm (4 in.) is on the in-feed table.
2. If the film has a release liner (B):
•
Install the Wind-up Tube on the machine.
•
If your machine has a splitter tube, web the film under the tube.
•
Peel back corner of release liner.
•
Pull the release liner off laminate and stick it to the tube with tape.
An empty card board tube from a used roll of film can be attached to the Wind-up tube to take
up the release liner. This allows the release liner to be easily removed from the Wind-up tube and
used for other processes if needed.
3. Raise table to full open position.
4. Raise top roll to full open position.
5. From the back of machine, pull film though nip and stick to out-feed table. Ensure film is flat
against top roll. Add more unwind brake if necessary.
6. If using Lower Unwind Shaft to feed images or release liner:
•
Insert material into nip making sure it is laying flat on bottom roll.
•
Hold material in place with one hand.
•
Lower top roll to full close (zero) position.
Note: Use a release liner on bottom unwind or a carrier board when processing thin images.
7. Lower table to the full down position.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
17