Introduction
Congratulations on your purchase of the Echo Relay Panel Feedthrough (ERP-FT). The ERP-FT
panel offers high value power control with a small footprint, low heat dissipation, and low
noise, allowing it to be installed in a variety of locations. Features of the ERP-FT panel include:
sACN, DMX-512, or stand-alone control
•
Configuration using the web user interface
•
Control for up to 48 relays
•
120V-347 V single-pole and 120/208 V or 277/480 V double-pole switching
•
120 V, 277 V, and 347 V circuits can be wired into the same panel
•
Voltage barriers available to separate normal and emergency branch circuits
•
Option cards allow for broadcast DALI control, 0–10 V control, and contact closure input
•
UL 924 listed Panic Input (dry contact input) suitable for connection to external emergency
•
systems
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
Do not use outdoors.
•
Do not let power supply cords touch hot surfaces.
•
Do not mount near gas or electric heaters.
•
Equipment should be mounted in locations and at heights where it will not readily be
•
subjected to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the manufacturer may cause an
•
unsafe condition.
Do not use this equipment for other than intended use.
•
SAVE THESE INSTRUCTIONS
Introduction
1