Installing On The S7-1500 Standard Rail - Siemens SIMATIC NET SCALANCE M874 Operating Instructions Manual

Industrial remote communication remote networks
Table of Contents

Advertisement

Installation and removal
4.6 Installing on the S7-1500 standard rail
7. Connect the device to the local network, refer to the section "Ethernet port (Page 66)".
8. Connect the terminal with as short a cable as possible ≤ 150 mm and a large cross-sectional
area ≥ 1.5 mm² to the functional ground of the system, refer to the section "Grounding
(Page 60)" and section "Terminals (Page 30)".
Uninstalling
1. Disconnect all connected cables.
2. Using a screwdriver, pull down the catch on the rear of the device.
3. Remove the device from the mounting rail.
4.6

Installing on the S7-1500 standard rail

Requirement
There is a mini SIM card for the device.
Installation
1. Insert the SIM card, refer to the section "SIM card (Page 67)".
2. Place the first housing guide of the device on the top edge of the mounting rail
3. Using a screwdriver, pull down the catch
48
on the rear of the device.
Operating Instructions, 02/2023, C79000-G8976-C331-12
.
SCALANCE M874, M876

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simatic net scalance m876

Table of Contents