Reconfiguring An Iot Device - Broadcom WICED 4343W User Manual

WICED User Manual
5. In the WICED Device Configuration webpage select the AP that the IoT device will use to connect to the
Internet, enter the password, and click Connect.
Note: If connecting to an AP that does not broadcast its SSID, click on Add network manually.
6. Observe the following message on successful connection to the selected AP.
The IoT device is configured to communicate using the AWS IoT service. After the above message is displayed,
the Wi-Fi module exits configuration and starts running the preloaded app, which in the case of the BCM4343W
IoT Starter Kit, is the Shadow app.

Reconfiguring an IoT Device

To reconfigure an IoT device (upload a new AWS certificate or private key, or connect to another AP):
1. Press SW1 (the Reset button).
2. Press and hold SW2 for five seconds.
Performing the above steps clears Wi-Fi module memory and puts the IoT device back into its SoftAP mode
where it can once again be configured.
Broadcom
®
November 19, 2015 • WICED-UM200-R
Configuring an IoT Device
Page 54