11
SERVICE WORK ON THE CHASSIS
11.10
Installing the lower triple clamp
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether upper steering head seal
–
Slide on protective ring
102146-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
K00464-10
–
Position the fork legs.
Bleeder screw
Valve
Info
The air suspension AER valve is located in the left fork leg.
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
H01182-11
–
Tighten screws
Guideline
Screw, bottom triple clamp
K00473-10
–
Tighten screw
Guideline
Screw, top steering head
K00465-10
p. 129)
and O-ring
but do not tighten yet.
of the right fork leg is positioned to the front.
of the left fork leg faces the front.
.
.
is correctly positioned.
.
M8
12 Nm (8.9 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
46