11
SERVICE WORK ON THE CHASSIS
–
Pull at the top part of the chain with the specified weight
Guideline
Weight, chain wear measurement
–
Measure distance
Info
Chain wear is not always even, so you should repeat this measurement at
different chain positions.
Maximum distance
chain section
»
If distance
–
Change the drivetrain kit.
400987-10
–
Check the chain sliding guard for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain sliding
guard
M01166-10
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding piece
S01250-01
of 18 chain rollers in the lower chain section.
at the longest
is greater than the specified measurement:
Info
When a new chain is mounted, the rear sprocket and engine
sprocket should also be changed.
New chains wear out faster on old, worn sprockets.
M6
.
10... 15 kg (22... 33 lb.)
272 mm (10.71 in)
6 Nm
Loctite
(4.4 lbf ft)
M8
15 Nm
(11.1 lbf ft)
62
®
243™