Restore Factory Default Settings - IOGear M1102-a User Manual

Restore Factory Default Settings

This restore will change all settings back to default. This will also have administrator and all user accounts
removed from the KVM. All port names and setting will also be removed. In other words, everything will be
changed as if it is a brand new unit.
Step 1
Unplug the DC connector from the KVM, then
remove the housing of the KVM.
Step 2
Using a jumper cap, short the
jumper on the main board
labeled J17.
60
Step 3
Now plug the DC connector back into the DC
jack from the KVM. This will restore the KVM with
factory default firmware.
Step 4
A message will appear on the monitor as below.
Step 5
Unplug DC connector from the KVM, then remove
the jumper and screw the housing back on the
KVM.
Final Step
Plug DC connector back into the KVM, then the
KVM will be ready for usage again.
61