IOGear M1102-a User Manual page 17

Port ID Display Position
This function allows you to change the position
of the port ID that's showing on the screen as the
image below. Simply change the position by using
the up, down, left and right arrows to adjust to
the place that you want the port ID to show in the
future and press [Enter].
Port ID Display Duration
This function allows you to change the port ID
display duration between 3 seconds and off.
Simply move the red highlight bar to the option
that you would like to choose and press [Enter].
Then, press [Esc] to exit this function.
32
Port ID Display Mode
This function allow you to choose the way you
want to show the ports in the OSD main screen –
port number only, port name only or both. Simply
move the red highlight bar to the option that you
like to use and press [Enter]. Then, press [Esc] to
exit from this function.
Scan Duration
This function allows you to set the autoscan time
interval between 0 second to 255 seconds (5
second is set by default). Simply enter the number
between 0-225 and press [Enter].
33