Pan Dimensions; Using Your Induction Hob - Candy CIDSCS633TT/1 Instruction Manual

Pan dimensions

The cooking zones are up to a limit, automatically adapted to the diameter of the
pan. However the bottom of this pan must have a minimum of diameter according
to the corresponding cooking zone. To obtain the best efficiency of your hob,
please place the pan in the centre of the cooking zone.
The base diameter of induction cookware
Cooking zone Minimum (mm)
1,2(180mm) 120
3 (280mm) 180
The above may vary according to the quality of the pan used.

Using your Induction Hob

To start cooking
1. Touch the ON/OFF control.
After power on, the buzzer beeps once, all displays show
" – " or " – – ", indicating that the induction hob has entered
the state of standby mode.
2. Place a suitable pan on the cooking zone that
you wish to use.
• Make sure the bottom of the pan and the surface
of the cooking zone are clean and dry.
3. Touching the heating zone selection control, and
a indicator next to the key will flash.
4. Set a power level by touching the "-", "+", or slide along the "—"control,
or just touch any point of the "—".
EN-11
Or
a. If you don't select a heat zone within 1 minute, the ceramic hob will
automatically switch off. You will need to start again at step 1.
b. You can modify the heat setting at any time during cooking.
c. If slide along the "—", power will vary from stage 2 to stage 8.
Press "-", power will decrease by one stage each time till stage 0.
Press "+", power will increase by one stage each time till stage 9.
If the display flashes
setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is placed
on it.
When you have finished cooking
1. Touching the heating zone selection control that you wish to
switch off.
2. Turn the cooking zone off by touching the "-"and scrolling down to "0".
Or slide along the "—" to the left point, and then touch the "-".
Or touch the left point of "—", and then touching the "-".
Or
alternately with the heat
EN-12