Power Supply Requirements; Features Diagram - Anvil MWA2100 Installation, Operation And Care Manual

Commercial microwave oven
Table of Contents

Advertisement

POWER SUPPLY REQUIREMENTS

Improper Use Of The Oven Can Cause Serious Risk Of
Electric Shock. Important guidelines are provided below.
1. The oven requires a 230-240 Volt, 50Hz, 15amp power supply.
2. The oven is fitted with a 3 pin Australian Standard earth plug top.
3. This appliance must be earthed. In the event of an electrical short circuit the earthing
reduces the risk of electric shock by providing an escape wire for the electric current.
The oven is supplied with a power cord with an earthed plug top. Consult a qualified
electrician if the earthing instructions are not fully understood or if doubt exists that the
appliance is correctly earthed.
4. If it is necessary to use an extension lead use only a 3 wire earthed extension lead.
The marked rating of the extension lead should be equal to or greater than the electrical
rating of the oven.
5. If the power lead or plug is damaged in any way do not use the oven. Please contact
your supplier for the nearest qualified repairer to repair the oven.

FEATURES DIAGRAM

A. Control panel
B. Door glass
C. Safety interlock latch
D. Ceramic base
E. Air filter
F. Plug
G. Exhaust vent
Note
1. Do not press down on the ceramic
base.
2. Use caution when placing dishes
on the ceramic base.
3. Use caution when removing items
from the oven as the ceramic base
can become very hot.
D
C
E
3
A
B
G
F

Advertisement

Table of Contents
loading

Table of Contents