Table of Contents
Advertisement
AIR FILTER CLEANING
It is important to keep the air filter clean at all times. The air filter prevents grease, fat, dirt,
etc from entering the oven and damaging sensitive components. Failure to keep the air filter
Filter cleaning
clean may cause overheating of the oven resulting in the oven cutting out or damage to key
components.
1. Turn the filter screws counterclockwise to unscrew and remove the air filter.
2. Wash the air filter using warm soapy water.
3. Reposition the air filter and secure by tightening the filter screws in a clockwise direction.
Filter
Filter
AIR FILTER CLEANING REMINDER
The front filter serves as the air inlet; the filter
on time to keep the chamber clean.
The oven can be programmed to remind the user to clean the air filter every 7, 30 or 90
days. The factory default setting reminder is every 30 days. However, the user can change
1. T urn counterclockwise to unscrew and take down
this time by following the guidelines in the Custom User Settings on page 10.
it with warm soap water;
The oven display will show "CLEAN FILTER" after the selected reminder time has
2. Install the filter screen Tighten clockwise the screws to fix the filter ;
been reached. Follow the sequence below to reset this message.
1. Press "STOP" or open and close the oven door to to return to Ready Mode.
3. Make sure the filter is installed before use of the microwave oven;
2. Press the "STOP" button for 3 seconds to clear the "CLEAN FILTER" reminder message.
4. The factory setting has the function to remind the user of washing the
NOTE. The Air Filter Cleaning Reminder does not detect if the filter is dirty, rather it is a
every 30 days.
reminder based on time. The filter should be inspected daily and cleaned as soon as it
(6) Splash shield cleaning
becomes dirty even if the reminder message is not displayed.
1. Detaching: Hold the two buckle positions in front of
hands (as shown by the arrows). Exert your strength following the direct
the arrows and pull downwards after you have pulled out the buckles:
2. Wash the splash shield:
3. Installation: Pick up the splash shield and obliquely put it into the cham
the way that insert the first
plate of chamber , then push the other side to insert all positioning pins in
positioning holes.
Caution!
Never operate the oven
without the air filter fitted.
Caution! Make sure the splash shield is installed
Filter Screws
Filter screws
pin at the rear into the positioning hole on the
13
correctly before use of the microwave o
should be cleaned
the filter ; and wash
the splash shield w
Advertisement
Table of Contents
