Table of Contents
Advertisement
START / +30 SEC
START / +30 SEC allows you to reheat for 30 seconds at 100% (full power) by simply touching the
START / +30 SEC pad.
By repeatedly touching the START / +30 SEC pad, you can also extend reheating time to 5 minutes
by 30 second increments.
1. Touch START / +30 SEC pad.
START /
+30 SEC
CHECK FUNCTION
This feature allows you to check the programmed cooking time and power level.
1. Touch CHECK pad.
CHECK
2. Touch the NUMBER pads
which you want confirmation.
ex)5
The display will show cooking time, power level each stage.
If you want to end, touch STOP/CLEAR pad.
DOUBLE QUANTITY FUNCTION
This feature allows you to extend programmed cooking time to heat double quantities temporarily.
The maximum double quantity heating/cooking time cannot exceed the times below;
Maximum cooking/heating time at 100% power is 20 minutes.
Maximum cooking/heating time is 60 minutes when less than full power (100%).
1. Touch DOUBLE QUANTITY pad.
DOUBLE
QUANTITY
2. Touch the NUMBER pad.
(ex. number pad 1)
When you touch START / +30 SEC, ":30" is
displayed.
The oven will start immediately. It will add 30
seconds to the time counting down each
time the pad is touched.
The display will show "CHECK".
The display will show "PROG-05".
The display will show "DOUBLE".
The display will show "PROG-01".
To select pads 11 to 20, touch number pad
twice rapidly.
(ex. to select pad 11, touch number pad
1 twice rapidly.)
After 1.5 seconds, the oven automatically
start cooking.
15
8
CHILD SAFETY LOCK
The safety lock prevents unwanted oven operation such as by small children.
To set, press and hold STOP/CLEAR for 3 seconds, LOCK indicator lights.
To cancel, press and hold STOP/CLEAR for 3 seconds, LOCK indicator goes off.
POWER SAVE MODE
This function is used for saving energy.
To set, press and hold CHECK pad for 3 seconds. The oven will beep and nothing appears in the
display. Now the oven is in power save mode.
To operate the oven in power save mode, press any pad. Then " : 0" will show and the operation of
all function key will be same as in normal mode.
If there is no operation within 10 seconds in clear mode or while manipulating the key, all the
contents of display will disappear.
To cancel, after press any pad, press and hold CHECK pad for 3 seconds.
Then the oven is again available for normal use.
MUTE FUNCTION
To set, press and hold DOUBLE QUANTITY pad for 3 seconds.
The display will show "MUTE" for 1 second.
Buttons will no longer beep when pressed.
To cancel, press and hold DOUBLE QUANTITY pad for 3 seconds.
TO STOP THE OVEN WHILE THE OVEN IS OPERATING
1. Press STOP/CLEAR pad.
• You can restart the oven by touching START pad.
• Touch STOP/CLEAR once more to erase all instructions.
2. Open the door.
• You can restart the oven by closing the door and touching START.
NOTE: Oven stops operating when door is opened.
ERROR MESSAGES
• "E10" message occurs when the total sum of the stage cooking time is
E10
greater than 20 minutes in full power or 60 minutes in other power levels.
• Press STOP/CLEAR key and try again.
• "E20" message occurs when EEPROM is not able to read cooking data
E20
from itʼs memory or write cooking data on itʼs memory.
• Unplug the power and call for service.
16
9
Advertisement
Table of Contents
