ATEN KN1132V Series User Manual page 40

KVM over IP User Manual
No. Component
8 port switching
buttons
9 power sockets The power cable(s) plugs in here. The left power socket
10 power switch
11 primary LAN
port
12 PON port
13 secondary
LAN port
14 serial port
15 local console
port(s)
16 KVM ports
17 grounding
terminal
22

Press PORT DOWN to manually switch from the current port
to the previous port on the installation.

Press PORT UP to manually switch from the current port to
the next port on the installation.
corresponds to the left power switch, and the right power
socket corresponds to the right power switch.
These standard slide switches power the unit on and off.
The cable that connects the unit to the primary network
interface (10/100/1000 Mbps) plugs in here.
This connector is provided for a Power over the Net™ (PON)
unit which allows servers attached to the KVM over IP switch to
be booted remotely over the net.
See KN8032VB / KN8064VB Single-Stage Installation on
page 34, step 6 for installation details. Contact your dealer for
more information regarding PON units.
The cable that connects the unit to the backup network
interface (10/100/1000 Mbps) plugs in here.
This port can be used for a serial device; or for a dial in
connection should the unit be unavailable over the network.
See KN8032VB / KN8064VB Single-Stage Installation on
page 34, step 7 for installation details.
The unit can be accessed via a local console as well as over
the net. The local console devices (USB keyboard, USB
mouse, VGA or HDMI monitor) plug in here.
The Cat 5e cables that link the unit to the KVM Adapter Cables
(which connect to the servers), plug in here.
The wire used to ground the unit connects here.
Description