Working Mode - ATEN KN1132V Series User Manual

KVM over IP User Manual

Working Mode

An explanation of the Working Mode items is given in the table, below:
Item
Enable FIPS Enables the FIPS security standard.
Enable Multiuser Enabled by default, Multiuser operation permits up to 32 users to
Operation log into and share the same remote bus. When disabled, the
maximum number of users allowed to log in simultaneously is
equivalent to the number of remote buses of the device (see Bus
Support, page 1).
Enable Virtual Enabling Virtual Media Write Operation allows redirected virtual
Media Write media devices on a user's system to send data to a remote server,
Operation as well as being able to have data from the remote server written to
them.
Enable Local Enabling Local Virtual Media allows USB storage peripherals (CD/
Virtual Media
DVD, HD, flash drives, etc.) connected to the KVM over IP switch
to appear and act as if it were installed on a remote system.
Disable If Disable Authentication is checked, no authentication procedures
Authentication are used to check users attempting to log in. Users gain
Administrator access to the KVM over IP switch simply by entering
combination of username and password.
Note: Enabling this setting creates an extremely dangerous result
as far as security goes, and should only be used under very special
circumstances.
202
Explanation