Table of Contents
Advertisement
A
ssembly
The only tool you'll need to
assemble your vacuum cleaner
is a Phillips head screwdriver.
Attach handle to vacuum
1. Stand the vacuum upright and slide
the base of the handle firmly into the
grooves at the top of the vacuum body.
2. Check to be sure the handle is fitted
to the vacuum body. If there is a gap
in front, continue to push firmly until
the handle is flush.
3. Insert one screw from the assembly
packet into the existing hole in the
back of the handle. Tighten securely
with a screwdriver.
Attach vacuum hose and tools
1. Position the hose collar on the back of
the vacuum as shown.
2. Attach the hose collar with two screws
from the assembly packet. Tighten
securely with a screwdriver.
3. Line up the tabs on the base of the Twist
'n Snap Hose with the corresponding
tab notches on the hose collar as shown.
Turn the Twist 'n Snap Hose to the left to
lock the hose into place.
4. Grasping the Quick Reach® Handle,
slide the end of the hose wand onto
the suction intake opening. Snap the
hose into the hose clip.
NOTE: The powerfoot will not
operate effectively unless the
hose wand is firmly attached
to the suction intake opening.
5. Place the crevice tool inside the
extension wand and slide them into
the storage clip as shown.
6. Snap the combination upholstery/
dusting brush tool into the storage
clip as shown.
w w w . b i s s e l l c o m m e r c i a l . c o m
WARNING:
Plastic film can be dangerous.
To avoid danger of suffocation,
keep away from babies
and children.
1.
1.
3.
4.
5.
6.
8 0 0 . 2 4 2 . 1 3 7 8
3.
Hose
Collar
5
Advertisement
Table of Contents
