Attach Handle To Vacuum; Attach Vacuum Hose And Tools; Power Switch - Bissell PowerGroom 92L3R User Manual

Remanufactured 92l3 series
Table of Contents

Advertisement

A
ssembly
the only tool you'll need to assemble
your vacuum cleaner is a phillips
screwdriver.

attach handle to vacuum

1. Locate the handle and cord wrap. Remove
the screw packet taped to the handle.
2. Stand the vacuum upright and from the
rear of the unit, slide the base of the
handle firmly into the grooves at the top
of the vacuum body.
3. Ensure that the handle fits firmly to the vacuum
body. If there are any gaps, continue to push
firmly until the handle is secure.
4. Insert the provided screw into the exist-
ing hole, attaching the handle to the
body of the vacuum. Tighten securely
with a screwdriver.

attach vacuum hose and tools

1. Attach the Twist 'n Snap
the tabs on the base with the corresponding
notches on the back of the vacuum as shown.
2. Turn the Twist 'n Snap Hose to the right
to lock the hose into place.
3. Grasping the Quick Reach
slide the end of the Hose Wand onto the
Hose Wand Base. Snap the Hose into
the Hose Clip.
note: the vacuum will not operate
effectively unless the hose wand is
firmly attached.
4. Slide the extension wand and crevice tool
into the storage clip on back of vacuum.
5. Slide the dusting brush/upholstery tool
into the storage clip on back of vacuum.
6. Store the TurboBrush
handle by lining up the TurboBrush base
with the base of the holder then push
back to snap into place.

power switch

the power switch is located on the left
side of the vacuum. push the rocker
switch "on" (i) to vacuum, and "off"
(o) when cleaning is complete.
w w w . b i s s e l l . c o m
Hose by lining up
Handle,
®
on the front of the
®
caution:
Do not plug in your vacuum
cleaner until you are familiar with
all instructions and operating pro-
cedures.
2.
1.
Twist 'n
Snap Hose
caution:
Before using your vacuum, make
sure that the dirt container is in
locked position and that all fil-
ters (inner circular, outer circular,
pre-motor and post-motor) are
in place. Do not operate your
vacuum without these filters.
8 0 0 . 2 3 7 . 7 6 9 1
4.
3.
6.
5

Advertisement

Table of Contents
loading

Table of Contents