Transmitting While The Scan Is On; Making A Dynamic Priority Change (Conventional Scan Only) - Motorola APX MOBILE O9 CONTROL HEAD User Manual

Note:
In the conventional system, while the radio is
scanning for activity, you can still receive
fleetwide, system-wide, dynamic regrouping,
incoming telephone interconnect, and Private
Conversation/Call Alert calls. The respond to
these types of calls are similar as you usually
do on the selected channel. However, when
scanning different channels while in talkgroup
scan, incoming Private Conversation/Call Alert
calls may be missed.

Transmitting While the Scan is On

Transmitting Using Radio Programmed for
Talkback Scan
Press the PTT button to transmit on the channel
indicated by the display.
The radio does not begin scanning again for a
predetermined hang time after you release the
PTT button, allowing the other party to respond. If
the other party responds within the hang time,
scanning does not resume until the full hang time
expires after they have finished speaking, allowing
the conversation to be completed.
74
English
To transmit on the selected channel if another
channel is active, first turn scan off by pressing the
Menu Select button below Scan momentarily.
Transmitting Using Radio Programmed for Non-
Talkback Scan
Press the PTT button at any time to transmit on
the selected channel or fixed channel.
To make a Call Alert page, or Private
Conversation call while scanning, press either the
Menu Select button directly below page or call.
The call is entered on the selected channel and
scanning is halted until the call is exited by
pressing or pressing the Menu Select button
below either page or call.
Making a Dynamic Priority Change (Conventional Scan
Only)
While the radio is scanning, the dynamic priority
change feature allows you to temporarily change any
channel in a scan list (except for the Priority-One
channel) to the Priority-Two channel.
This change remains in effect until scan is turned off.
Scan then reverts to the preprogrammed (original)
setting.